OREI 1 X 8 HDMI Extender. This HDMI extender splitter includs one transmitter and two receivers, extend 1 HDMI source to 2 HDMI displays over single CAT6/6a/7 cable up to 50m/ 164ft. The highest resolution supported is 1920×[email protected], and it supports IR passback, EDID pass through and only one power adapter for the transmitter is needed,the Receiver is powered by the transmitter over CAT6 cable. Ideal solution for HDMI exhibition, Video conference and show center, ect. Specification: HDMI Singal: HDMI 1.3, Compatible with HDCP1.2 Resolution Supported: [email protected], [email protected], [email protected], [email protected], [email protected]/60Hz,[email protected]/60Hz,[email protected]/60Hz CAT6/7: up to 50m (165ft) at [email protected] IR Singal: Support 20~60KHz IR device Audio Format: PCM, LPCM EDID: Support EDID setting fuction Network cable: UTP/STP CAT6/6a/7 Power Supply: DC5V/2A Power Consumption:
Although at 1st I got no video once you read the manual you'll understand that you simple have to setup edid and the box specs to the proper cable length and the video popped right up. The down side is that the video signal goes in and out and I'm not sure why.
Worked great right out of the box. I used 5 of the 8 ports. Very little setup.
Really simple to use and install. Much cheaper than running an hdmi splitter and a bunch of hdmi cords. Installed this in a large church with long cable runs and it is working great. Don’t make the mistake I did though, make sure you use cat6 or better.
I needed to repeat a signal 125' feet and I wanted 1080p signal. This unit worked as described and has been very reliable for the months we have had this installed!
These have come along way. I had single units that required the receiver to plug into wall power. These only require power at sender, allows for a clean installation.
Installed in a church with cat6a sheilded cable. No issues at all. Various lenths from 50 to 150ft.
Great product and I had the ability to use for multiple connectivity.