Limited Blue Venu Edition GBA Housing Shell Pack for Gameboy Advance To Replace Damaged Or Defective Original Shell
Colored Buttons With Lens Housing shell, X+Y-screwdrivers,A,B,D-Pad Button and Sticky Label,
No Conductive Rubber Buttons and No Select Start
Remember to Peel Off The Film Front From The Lens
Warning Tips:No Conductive Rubber Buttons and No Select Start, need to use your old one
This is great, the shell looks good. My old power button was really sloppy, was worried this wouldn't fix it. It is now tight and feels like-new. The only complaint I have is that the screw holes are not pre-drilled they are solid plastic and you run the screw into them, was 1/2 way on the first screw before I noticed. (I read someone say the screws didn't fit and thought that was the issue) I would recommend you run the screws through all the holes before installing your old GBA just to be careful.
missing a couple of screws but I was able to re-use the ones my device came with. pretty slick install, just make sure to put the clear plastic piece in place before closing it up (the clear plastic piece directs the power light through the hole so you can tell its on) or you will have to take it apart again... that is on me though. No directions in my package but it is easy enough to figure out.
Definitely an excellent company to purchase from. I've purchased a few EXSEK products, including the EZ Flash Omega, and have been amazed at the quality of their products. The screen lense is crystal clear and very east to instal. It's a great fit, if you've modded your gba with a backlight, do all the trimming you can because the screen has very minimal flex compared to the original plastic, which will leave the glass screen sticking out about 1/32 of an inch up out of the shell in whatever areas that aren't trimmed properly. This us an excellent product and I would recommend it to anyone replacing the original.
Excellent package! It comes with all the parts needed to change the shell and buttons, and the two drivers needed( Y wing, and Phillips head) to change the screws- and even new screws to replace your old ones. the feel of the plastic used feels around the same as the nintendo one used in the original shells and buttons.
Great product and includes everything you need. Would buy again. Would’ve been 5 stars but was missing 2 screws, easy fix though as I just utilized the old screws. Amazing color scheme also, love playing Super Mario World on it. Takes me back to the good ole days.
Product is great quality. Purchased the transparent orange buttons. Unfortunately the trigger buttons from this kit did not fit properly into a OEM shell so I could not use them. All other buttons fit fine. Still looks good with the original triggers, but would have been nice to have it all match. Would still recommend this product as long as you are not too concerned with some pieces not fitting. Seller also sells the shell itself which I would assume the triggers would fit in.
Nice case that allowed me to make a gameboy zero completely black setup. Would buy again if someone else wanted that color scheme.